Why are the AutoMod “Anti-raid” switch and the Anti-raid page linked?
On the AutoMod page you see an Anti-raid module with two settings, and the Anti-raid & anti-nuke page has its own switches. These are not two protections: there is only one engine, and the two places mirror each other.
What happens when you touch AutoMod
| You do | Effect on the Anti-raid page |
|---|---|
| Turn on Anti-raid in AutoMod | “Protection enabled”, “Join analysis” and “Automatic lockdown” are turned on (the recommended setting). |
| Turn off Anti-raid in AutoMod | “Protection enabled” is turned off: the whole Anti-raid page stops acting. |
| Set Anti-raid floor (joins) and Floor window (seconds) | They become “Floor: joins” (from 2 to 50) and “Floor: window (seconds)” (from 1 to 30). |
In the other direction, what you set on the Anti-raid page is reflected in AutoMod.
Turning one off turns the other off
If you switch off “Anti-raid” in AutoMod for a test, the anti-nuke on the Anti-raid page stops too, since it is the same main switch. Remember to turn it back on.
Where do I set the details?
AutoMod only shows the essentials. Fine settings (crowd analysis, lockdown, anti-nuke, watch) are on the Anti-raid & anti-nuke page.
Still stuck?
Contact support with the title of this article, the step where you are stuck and what you see on screen.
Contact support More articles: ProtectionLast checked: 13 November 2026.